Shenyang All-Powerful Science & Technology Stock Co. LTD Tel:+86-24-24699053 E-mail:owen@apw.cn Address: 15-1,Hunnan East Road, Shenyang, Liaoning Province, China
APW waterjet training

In this section, we will detail waterjet pump installation requirements and procedures. These operating rules require thorough understanding to all of the components.

Waterjet Pump Requirement

Waterjet >> Waterjet Cutting Services >> Waterjet Training >> Waterjet Pump Requirement

Waterjet Pump Requirement

Waterjet Pump Requirement

The environment temperature ranges from 10°C to 30°C. The relative humidity should be 40% ~ 75% RH.

warning flash

Ultra-high pressure pump should not be installed in the place whose temperature is below zero. If the temperature is going to be below freezing point, please discharge the water in the pipe and filter in advance.

Environment temperature for stock: -10 ~ 50°C.

warning flash

If pipes, valves are frozen, do not operate equipment. System must be completely defrosted until the water can flow freely in the system.

Atmospheric pressure is 86 kpa-106 kpa. Dust concentration in air shall not be greater than 10 mg/m3, and shall not contain acid, salt, and corrosive gases.
Equipment should be away from the vibration source, heat source, interference sources and heat flow. The vibration in the workshop should be under 0.5G.
The ground must be able to support the weight of the machine, and thick enough to resist the vibration of the machine.
For maintenance, ultra-high pressure pump shall be set aside at least 900 mm on each side of the interval.

Power Requirement

careful sign

All power supply and remote control wiring used in ultra‐high pressure pump must comply with the local electrical standard and the national electrical principle.

attention sign

Working voltage and ampere capacity must meet the relevant requirements.

Three-phase five wires, 380V, 50Hz. Power cables should be the cable in size of 16 mm2 × 3+1 × 6 mm2; the other should be grounding wires with 6 mm2.
Ground wire is needed. It is required to distinguish the ground wire and the neutral strictly.
Input voltage value should be +/-5%.
Rated input power frequency should be +/-1%.

attention sign

If the voltage and current fluctuation surpass the prescribed requirement, it may cause damage for ultra-high pressure jet pump.

Power capacity: 42KW(380MPa)
Please refer to "electrical parts manual" for details.



APW facebookAPW google+APW twitterAPW linkedin
Tel:+86-24-24699053 E-mail:owen@apw.cn
Copyright©2016 Shenyang All-Powerful Science & Technology Stock Co. LTD All rights reserved