Popularize the daily maintenance of waterjet cutting machines

Good use of the cutting platform and careful and complete maintenance will reduce the maintenance cost of the waterjet cutting machine platform. Today we will popularize the key points of daily maintenance of waterjet cutting machines:
    1. The water jet cutting machine platform should always lubricate linear guides, ball screws, nut supports, etc., in principle, manual lubrication is required for every 2 hours of continuous operation of the machine.

    2. It is necessary to fill the oil pump with oil frequently so that the oil level is not lower than the lowest oil level mark.

    3. The abrasive sand and leftover materials deposited in the sink need to be removed regularly, at least once a month.

    4. The industrial computer should be used as a special machine for water cutting machine. The hard disk must have enough space to install anti-virus software to meet the needs of cutting complex parts.

    5. It is necessary to protect the connecting cable between the electric control box and the cutting platform and the high-voltage generator. It is strictly forbidden to step on or squeeze the cable. The cable should be placed in the metal wire slot.

    6. Frequent replacement of the grid bar to affect the accuracy of cutting.

    7. Always fill the drain valve of the water tank with oil to prevent the valve from rusting.

    8. The sand storage container should be kept dry. If water enters the sand pipe and tank due to backwater, all sand in the sand storage container and pipeline must be removed, and then dried and filled with dry new sand.

    9. After finishing work every day, clean up the site and make safe and civilized production.