The maintenance work of waterjet cutting machine cannot be underestimated

Waterjet cutting machines need regular maintenance, because if there is a waterjet cutting machine that does not work properly, it will affect the processing efficiency of the ceramic tile processing factory, so the maintenance of the waterjet cutting machine is very important. Sometimes it’s strange that the same manufacturer produces the same waterjet cutting machine. Why does someone else use it longer than you? Are others more efficient than you? Have you considered these issues carefully? The same waterjet cutting machine, because people operate it differently, different maintenance will have different results
The waterjet cutting machine is a waterjet cutting machine that splits the tiles into the required size through the high-speed rotation of the saw blade. At present, water jet cutting machines have been widely used in the processing industry.

The tile edging machine is to trim the processed tiles and repair the cut edges into the original factory edges.

The ceramic tile chamfering machine is to chamfer the original right-angled side to the desired angle.
Due to the different working principles of various waterjet cutting machines, there will be various problems. The following introduces several common problems. How to solve these problems and the daily maintenance are briefly introduced. a bit!
1. First check the power socket, plug, and power cord for oxygen loss or breakage. If the motor does not rotate, if the wheel can be turned slightly by hand, it can be concluded that one of the two starting capacitors of the waterjet cutting machine has failed. In this case, there is generally only a new product.
2. Check whether the lubrication of the bearing is good, and check whether all fasteners are tight. Check whether the drive belt is installed correctly and in good condition. If the belt is found to be damaged, it should be replaced in time. When there is oil on the belt or sheave, wipe it off with a clean cloth in time. Check whether the protective device is in good condition. If the protective device is found to be unsafe, it should be eliminated in time. Check whether there are materials or other sundries in the damaged cavity, and remove it if sometimes. Check whether the motor is installed correctly and pressed tightly.

Maintenance of waterjet cutting machine:
1. The shaft of the waterjet cutting machine bears the full load of the negative machine, so good lubrication has a great relationship with the life of the bearing, it directly affects the life and operation rate of the machine, so the injected lubricating oil must be clean and sealed Must be good.
2. The newly installed wheel tyres are prone to loosening and must be checked frequently.
3. Pay attention to whether all parts of the machine work normally.
4. Pay attention to check the degree of wear of easily worn parts, and pay attention to replacing worn parts at any time.
5. The bottom frame should be flat. Long-term processing will cause the tile edger to vibrate and move slowly. When it encounters unevenness, uneven processing of tiles will occur.
6. If the bearing oil temperature rises, stop the machine immediately to check the cause and eliminate it.
7. If there is an impact sound when the rotating gear is running, it should be shut down immediately for inspection and eliminated.